specification model rated current rated power output current adj. range setup, rise time hold up time (typ.) voltage range note.2 frequency range power factor (typ.) efficiency (typ.) ac current (typ.) input inrush current ( .)typ leakage current safety standards note.3 working temp. working humidity storage temp., humidity temp. coefficient vibration mtbf dimension others note packing over temperature over voltage can be adjusted by internal potentiometer a type only 16ms at full load 230vac / 115vac 1800ms, 80ms at full load 230vac /115vac 90 ~ 305vac 127vdc ~ 431vdc 47 ~ 63hz 0.88a / 115vac 0.45a / 230vac 0.38a / 277vac <0.75ma / 277vac -40 ~ +70 (refer to "derating curve") j 10 ~ 95% rh non-condensing -40 ~ +80 , 10 ~ 95% rh j ? j j 0.03%/ (0 ~ 50 ) 10 ~ 500hz, 5g 12min./1cycle, period for 72min. each along x, y, z axes 309.7k hrs min. mil-hdbk-217f (25 ) j 195.6*61.5*38.8 mm (l*w*h) ripple current environment safety & emc protection 85 10 (rth2) j? j 300 ~ 340v protection type : shut down o/p voltage, re-power on to recover protection type : shut down o/p voltage with auto-recovery or re-power on t o recovery short circuit 91.5% pf>0.98/115vac, pf>0.96/230vac, pf>0.94/277vac at full load (pl ease refer to "power factor characteristic" curve) HLG-80H-C350 HLG-80H-C700 ? 5% 1. all parameters not specially mentioned are measured at 230vac input, r ated load and 25 of ambient temperature. 2. derating may be needed under low input voltages. please check the static c haracteristics for more details. 3. safety and emc design refer to en60598-1, cns15233, gb7000.1. 4. the power supply is considered as a component that will be operated in combi nation with final equipment. since emc performance will be affected by th e complete installation, the final equipment manufacturers must re- qualify emc directive on the complete installation again. 5. refer to warranty statement. 6. constant current operation region is within 50% ~100% rated output vol tage. this is the suitable operation region for led related application s, but please reconfirm special electrical requirements for some specific syste m design. j compliance to en61000-4-2,3,4,5,6,8,11, en61547 , heavy industry level (surge l,n-fg: 4kv), criteria a approved ul8750, csa c22.2 no. 250.0-08, en61347-1, en61347-2-13 independ ent, ip65 or ip67 hiccup mode, recovers automatically after fault condition is remove d 210 ~ 350ma 420 ~ 700ma 350ma 89.95w a type : 128v ~ 257v b type : 167v ~ 257v 0.84kg; 16pcs/14.4kg/0.54cuft i/p-o/p:3.75kvac i/p-fg:2kvac o/p-fg:0.5kvac i/p-o/p, i/p-fg, o/p-fg:100m ohms / 500vdc / 25 / 70% rh j withstand voltage isolation resistance 91.5% 150 ~ 170v 700ma 90.3w a type : 64v ~ 129v b type : 84v ~ 129v ?? features : a : ip65 rated. constant current level can be adjusted through internal po tentiometer. b : ip67 rated. constant current level adjustable through output cable w ith 1~10vdc or 10v pwm signal or resistance. d (option) : ip67 rated. timer dimming function, contact mean well for deta ils. ?e?e ?e ?e ?e ?e ?e ?e ?e ?e ?e constant current designuniversal ac input / full range (up to 305vac) built-in active pfc function protections: short circuit / over voltage / over temperature cooling by free air convection output current adjustable through output cable or internal potentiometer ip67 / ip65 design for indoor or outdoor installations three in one dimming function (1~10vdc or 10v pwm signal or resistance) 5 years warranty (note.5) suitable for dry / damp / wet locations high efficiency up to 91.5% f m m 110 ip65 ip67 HLG-80H-C350 a 90w single output led power supply h l g - 8 0 h - c s e r i e s file name:HLG-80H-C-spec 2012-12-26 emc immunity emc emission current accuracy ? 5.0% compliance to en55015, en61000-3-2 class c ( 50% load) ; en61000-3-3 ? constant current region note.6 ripple & noise 1vp-p 0.5vp-p ? 1% line regulation ? 1% cold start 60a(t =410 s measured at 50% i ) at 230vac width peak g
mechanical specification case no.997a unit:mm sjtw 16awg 2c ?? ? ip65 rated. constant current level can be adjusted through internal (can access by removing the rubber stopper on the case.) potentiometer. 300 20 ? fg (green/yellow) 38.8 sjtw 16awg 3c ?? 195.6 171.8 ac/l(brown) ac/n(blue) 12 9.6 r ?? 4.2 4pl 300 20 ? +v(red) -v(black) io adj. 61.5 46.5 32 85.9 t case 30.75 ? t case: max. case temperature. a type:(HLG-80H-C_a) 300 20 ? fg (green/yellow) 38.8 sjtw 16awg 3c ?? 195.6 171.8 ac/l(brown) ac/n(blue) 12 9.6 61.5 46.5 32 -v(black) +v(red) dim-(white) dim+(blue) r ?? 4.2 4pl 300 20 ? sjtw 16awg 2c ?? sjtw 16awg 2c ?? 85.9 t case 30.75 ? t case: max. case temperature. b type:(HLG-80H-C_b) 90w single output led power supply h l g - 8 0 h - c s e r i e s file name:HLG-80H-C-spec 2012-12-26
derating curve static characteristics ambient temperature ( ) j load (%) input voltage (v) 60hz 90 100 125 135 145 155 165 175 180 200 230 305 100 90 80 70 60 50 40 load (%) (horizontal) -40 0 -15 -30 15 30 50 60 70 20 40 60 80 100 sjtw 16awg 2c ?? 300 20 ? fg (green/yellow) 38.8 sjtw 16awg 3c ?? 195.6 171.8 ac/l(brown) ac/n(blue) 12 9.6 r ?? 4.2 4pl 300 20 ? +v(red) -v(black) 61.5 46.5 32 85.9 t case 30.75 ? t case: max. case temperature. d type:(HLG-80H-C_d) ? ip67 rated. timer dimming function, contact mean well for details. dim+ (b type) dim- detection pwm & pfc circuit o.l.p. o.t.p. emi filter rectifiers power switching filter & rectifiers +v -v i/p fg control o.v.p. & o.l.p. pfc circuit block diagram pfc fosc : 70khz pwm fosc : 60khz 90w single output led power supply h l g - 8 0 h - c s e r i e s file name:HLG-80H-C-spec 2012-12-26
6 1 6 2 6 3 6 4 6 5 6 6 6 7 6 8 6 9 7 0 7 1 7 2 7 3 7 4 7 5 7 6 7 7 7 8 7 9 8 0 8 1 8 2 8 3 8 4 8 5 8 6 8 7 8 8 8 9 9 0 9 1 9 2 9 3 9 4 1 0 % 2 0 % 3 0 % 4 0 % 5 0 % 6 0 % 7 0 % 8 0 % 9 0 % 1 0 0 % 2 7 7 v a c 2 3 0 v a c 1 1 5 v a c 0 .8 8 0 .8 9 0 .9 0 .9 1 0 .9 2 0 .9 3 0 .9 4 0 .9 5 0 .9 6 0 .9 7 0 .9 8 0 .9 9 1 5 0 % 6 0 % 7 0 % 8 0 % 9 0 % 1 0 0 % 2 7 7 v a c 2 3 0 v a c 1 1 5 v a c HLG-80H-C series possess superior working efficiency that up to 92% can b e reached in field applications. efficiency (%) efficiency vs load (HLG-80H-C700a model) pf load (90w) constant current mode power factor characteristic typical led power supply i-v curve a typical led power supply may work in "constant current mode (cc)" to drive t he leds. mean well's led power supply with cc characteristic can be op erated at cc mode (direct drive, at area (a)). driving methods of led module vo(%) 100 50 50 95 (max.) io (%) constant current area hiccup protection (a) (b) load 90w single output led power supply h l g - 8 0 h - c s e r i e s file name:HLG-80H-C-spec 2012-12-26
dimming connection diagram for turning the lighting fixture on/off : using a switch and relay can turn on/off the lighting fixture. ? using the built-in dimming function on b-type model can't turn the lighti ng fixture totally dark. please refer to the connection method below to achieve 0% brightness of the lighting fixture connecting to the led power s upply unit. ? direct connecting to leds is suggested, but is not suitable for using addit ional drivers. 1.output constant current level can be adjusted through output cable by c onnecting a or 1~10vdc or 10v pwm signal between dim+ and dim-. resistance 2.the led lighting fixture can be turned on/off by the switch. n fg l relay blue brown green/ yellow ac/l ac/n HLG-80H-C b type dim+ dim- v(-) v(+) blue white black red switch adjuster 0~100k ohms resistance 1~10v dc voltage 10v pwm signal led lighting fixture dimming operation (for b-type only) ? reference resistance value for output current adjustment (typical ) ? built-in 3 in 1 dimming function, ip67 rated. output constant current lev el can be adjusted through output cable by connecting a resistance or 1 ~ 10vdc or 10v pwm signal between dim+ and dim-. ? please do not connect "dim-" to "-v". fg (green/yellow) ac/l(brown) ac/n(blue) -v(black) +v(red) dim-(white) dim+(blue) 60k [ 60% 60% 10k [ 10k /n [ 20k /n [ 30k /n [ 40k /n [ 50k /n [ 60k /n [ 70k /n [ 80k /n [ 90k /n [ 100k /n [ single driver multiple drivers (n=driver quantity for synchronized dimming operation) 1v 4v 7v 2v 5v 8v 3v 6v 9v 10v 10% 10% 20k [ 20% 20% 30k [ 30% 30% 40k [ 40% 40% 50k [ 50% 50% 70k [ 70% 70% 80k [ 80% 80% 90k [ 100k [ open open open 90% 90% 100% 100% resistance value dimming value percentage of rated current percentage of rated current ? 1 ~ 10v dimming function for output current adjustment (typical) 60% 60% 10% 10% 20% 20% 30% 30% 40% 40% 50% 50% 70% 70% 80% 80% 90% 90% 100% 100% duty value percentage of rated current 95%~108% ----- 95%~108% 95%~108% ? 10v pwm signal for output current adjustment (typical): frequency ra nge :100hz ~ 3khz HLG-80H-C 90w single output led power supply h l g - 8 0 h - c s e r i e s file name:HLG-80H-C-spec 2012-12-26
? waterproof connector waterproof connector can be assembled on the output cable of HLG-80H-C to o perate in dry/wet/damp or outdoor environment. HLG-80H-C i/p o/p led lamp ac source ? cable joiner pin configuration (female) pin configuration (female) size size m12 m15 4-pin 5a/pin m12-04 order no. order no. 10a max. suitable current suitable current 5-pin 5a/pin m12-05 10a max. 2-pin 12a/pin m15-02 12a max. up to four wires can be connected through this cable joiner bysoldering or clamping by tools. 66 26 20 r 25 cj04-2 suitable for 18awg~22awg cj04-1 suitable for 14awg~16awg o/p wires led lamp HLG-80H-C waterproof connection ? cj04 cable joiner can be purchased independently for user's own assembl y. mean well order no. : cj04-1, cj04-2. 90w single output led power supply h l g - 8 0 h - c s e r i e s file name:HLG-80H-C-spec 2012-12-26
|
